Cisco Systems DPC/EPC2325 DOCSIS Setup Advanced Settings VPN Termination Status

How Do I Configure My DOCSIS Residential Gateway?

Setup Advanced Settings - VPN Termination - Status Page

The following illustration is an example of a blank Setup Advanced Settings - VPN Termination - Status page. No VPN tunnels are configured.

Setup Advanced Settings - VPN Termination - Status Page Description

This section describes the section headings and field descriptions of the Setup Advanced Settings - VPN Termination - Status page. This page allows you to create, configure, and control IPsec VPN tunnels.

Note: You can set up and mange up to 50 different VPN tunnels.

Field Name	Description
IPsec Endpoint	Enables/disables the IPsec endpoint mode
Name	Displays the user-defined tunnel name entered from the VPN Setup
	page
Status	Displays the current connection state (Connected/NOT Connected)
Control	Displays one of the following three keys based on the current tunnel
	enable and connection state:

ƒ

ƒ

ƒ

Enable

Connect

Endpoint disabled

	Configure	Displays Edit or Delete keys used for settings management
	Add New Tunnel	Allows you to create a new tunnel configuration. When you click Add
		New Tunnel, the VPN Setup page opens
	Event Log	Allows you to access the Event Log page. The Event Log page shows a
		history of VPN connections and activity in chronological order and also
		displays the IP address of both endpoints on the tunnel (local and
		remote)
		Note: On the Event Log page, pressing the Refresh key updates the
		Event Log table to show any changes since the page was loaded.
		Pressing the Clear key clears the log table of its current contents and
		only the most recent data appears
4024320 Rev A		57