Cisco Systems DPC/EPC2325 DOCSIS important safety instructions Local Endpoint Settings

How Do I Configure My DOCSIS Residential Gateway?

Local Endpoint Settings

The following table describes the fields in the Local endpoint settings section of the VPN Setup page.

Field Name	Description
Address group type	Allows you to select the address group type for the local VPN access
	group. The following types are available:

ƒ

ƒ

ƒ

IP subnet

Single IP address

IP address range

Subnet	Allows you to enter Subnet information based on the selected Address
	group type as follows:

ƒ

ƒ

ƒ

For IP subnet, enter the subnet

For single IP address, enter only the specific IP address

For IP address range, enter the starting and ending IP addresses

Mask	Allows you to enter Mask information based on the selected Address
	group type as follows:
	ƒ For IP subnet, enter the subnet mask
	ƒ For single IP address, enter only the specific IP address in the
	Subnet field. Leave this field blank.
	ƒ For IP address range, enter the starting IP and ending IP addresses
Identity type	Allows you to select the local Identity type from one of the following
	options:

ƒ

ƒ

ƒ

ƒ

WAN IP address of the router (default)

User-specified IP address

Fully qualified domain name (FQDN)

Email address

	This is the identity that the far endpoint will use for identification of the
	VPN termination point. The remote VPN endpoint on the other end of
	the tunnel should match these settings for its remote endpoint settings
Identity	Allows you to enter the identity string after you have selected the
	identity type using one of the following formats:

ƒ

ƒ

ƒ

For IP address mode use the format xxx.xxx.xxx.xxx

For FQDN use the format "yourdomain.com"

For email address use the format "yourname@yourdomain.com"

The remote VPN endpoint on the other end of the tunnel should match these settings for its remote endpoint settings

60 4024320 Rev A