Cisco Systems DPC/EPC2325 DOCSIS important safety instructions Remote Endpoint Settings

How Do I Configure My DOCSIS Residential Gateway?

Remote Endpoint Settings

These settings control how the local endpoint (router) connects to the far VPN termination point (the other end of the VPN tunnel).

Field Name	Description
Address group type	Allows you to select the address group type for the remote VPN access
	group. The following types are available:

ƒ

ƒ

ƒ

IP subnet

Single IP address

IP address range

	The remote VPN endpoint on the other end of the tunnel should match
	these settings for its remote endpoint settings
Subnet	Allows you to enter Subnet information based on the selected Address
	group type as follows:

ƒ

ƒ

ƒ

For IP subnet, enter the subnet

For single IP address, enter only the specific IP address

For IP address range, enter the starting and ending IP addresses

Mask	Allows you to enter Mask information based on the selected Address
	group type as follows:
	ƒ For IP subnet, enter the subnet mask
	ƒ For single IP address, enter only the specific IP address in the
	Subnet field. Leave this field blank.
	ƒ For IP address range, enter the starting IP and ending IP addresses
Identity type	Allows you to select the remote Identity type from one of the following
	options:

ƒ

ƒ

ƒ

ƒ

WAN IP address of the router (default)

User-specified IP address

Fully qualified domain name (FQDN)

Email address

This is the identity that the far endpoint will use for identification of the VPN termination point. The remote VPN endpoint on the other end of the tunnel should match these settings for its remote endpoint settings

4024320 Rev A 61