18Patch Release Note
PCR: 03321 | Module: DHCP, Q931, TELNET | Level: 4 |
Debugging for DHCP and Q931 was not being disabled when a Telnet | ||
session finished. This issue has been resolved. |
| |
PCR: 03332 | Module: TTY | Level: 2 |
A log message is now created when a user is forced to logout from an asynchronous port when another user (i.e. someone connected via Telnet) resets the asynchronous connection with the RESET ASYN command.
PCR: 03333 Module: IPGLevel: 3
After VRRP was enabled, the link status of the switch ports was shown as UP, even if there was no connection to the ports. This issue has been resolved.
PCR: 03334 Module: MVRLevel: 3
The SET IP MVR command now has extra error checking. This is to ensure that if the IMTLEAVE parameter is not specified, the original range of ports set by the CREATE IP MVR command are still contained within the newly specified port range.
PCR: 03336 | Module: CORE | Level: 4 |
of the SHOW SYSTEM command. This issue has been resolved. |
| |
PCR: 03341 | Module: STP | Level: 3 |
STP ignored some BPDU packets coming in on tagged ports. This issue has been resolved. Now the VLAN tag is ignored on all devices except Rapier i Series Switches with multiple STPs on the receiving port.
PCR: 03345 | Module: IPG | Level: 4 |
The RESET IP COUNTER=ALL command was not working correctly when | ||
issued from the command line. This issue has been resolved. |
| |
PCR: 03346 | Module: SNMP | Level: 4 |
Sometimes the Agent Address field in SNMP traps was not the same as the IP source address. This meant that sometimes the NMS did not send an alarm to the network manager when traps were received from switches. This issue has been resolved.
PCR: 03348 | Module: SWI | Level: 3 |
The Uplink card sometimes unnecessarily changed its status from UP to | ||
DOWN. This issue has been resolved. |
| |
PCR: 03349 | Module: BGP | Level: 3 |
When there were a large number of BGP routes, the SHOW BGP ROUTE command sometimes caused an error. This issue has been resolved.
PCR: 03350 Module: IP, SWILevel: 3
A fatal error occurred if an IP ARP route entry was deleted after an IP route filter was added while the IP route was equal to zero. This issue has been resolved.
Patch
