Patch | 5 |
PCR: 03430 | Module: BGP | Level: 3 |
BGP traps were sent incorrectly when a BGP peer became Established, or moved into a lower state. This issue has been resolved.
PCR: 03432 | Module: STP | Level: 2 |
STP settings were not retained when a port was deleted from the VLAN that the STP belongs to. This issue has been resolved.
PCR: 03436 Module: IP, DHCP | Level: 2 |
When the device was acting as a DHCP client and the DHCP server provided a gateway address, a statically configured default route was deleted and replaced with a default route with the provided gateway address. The correct behaviour is to only delete a dynamic default route in this situation. This issue has been resolved; the correct behaviour is now applied.
PCR: 03439 | Module: IPX | Level: 3 |
The IPX traffic filter match counter was not incremented if a route was cached. This issue has been resolved.
PCR: 03441 | Module: L2TP | Level: 2 |
PPPconfigured on a L2TP access concentrator (LAC) should be dynamic. If PPP was incorrectly configured to be static, the static PPP was destroyed when the L2TP tunnel was formed so that only the first connection succeeded. This issue has been resolved so that an L2TP tunnel is not created if the PPP is static.
PCR: 03443 Module: DHCP | Level: 3 |
When a DHCP entry expired while other DHCP entries in the range were in Reclaim mode, unnecessary ARP packets were generated causing an ARP storm. This issue has been resolved.
PCR: 03444 | Module: FR | Level: 3 |
The CIR and CIRLIMITED parameter in the SET FRAMERELAY DLC command now regulates the behaviour of the transmission rate. Previously, the transmission rate did not reflect changes to the CIR setting if the new CIR was higher than the old CIR (provided that the new CIR is within the physical maximum of the network and the hardware), or changes to the CIRLIMITED setting if CIRLIMITED was turned ON then OFF. This issue has been resolved.
PCR: 03446 | Module: SWI | Level: 3 |
After unplugging a fibre uplink cable and then plugging it back in, a short
Ping timeout occurred. This issue has been resolved.
PCR: 03450 | Module: PIM, PIM6 | Level: 2 |
Receiving PIM State Refresh messages now creates and/or maintains PIM forwarding information.
PCR: 03453 | Module: FIREWALL | Level: 3 |
The dropped packets counter for the firewall was not incrementing correctly. This issue has been resolved.
Patch
