36

ADD PPP

Patch Release Note

ADD PPP

Syntax ADD PPP=ppp-interface OVER=physical-interface

[other parameters]

where:

ppp-interfaceis the PPP interface number, from 0 to 511.

physical-interface is:

SYNn

DS3n

ISDN-callname

ACC-callname

MIOXn-circuitname

TDM-groupname

TNL-callname

VLANn-servicename

Description This command adds a lower layer interface or link to an existing PPP interface. This configures PPP multilink, which groups links together for increased bandwidth. The following may be added:

a synchronous port

a DS3 port

an ISDN call

an ACC call

a MIOX circuit

TDM group

an L2TP call

a PPP over Ethernet service over a VLAN interface

The OVER parameter specifies the physical interface over which the PPP interface will run. For PPP over Ethernet and PPP over VLAN links, use the service name provided by your ISP, or the special service name ANY to specify that any service is acceptable.

Examples To add a PPPoE interface on VLAN2, using the service name ANY, as an additional physical interface to PPP interface 1, and enable STAC LZS compression on the synchronous link with a check mode of LCB, use the command:

ADD PPP=1 OVER=vlan2-any COMP=LINK STACCHECK=LCB

Patch 86251-05 for Software Release 2.5.1 C613-10356-00 REV F

Page 36
Image 36
Allied Telesis 86251-05 manual Add Ppp