Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers

25

Figure 2: Forwarding multicast data over a specified interface and port.

Multicast stream transmitter

Group 224.1.1.1

VLAN1

Rapier i

1 2 3 4

 

 

 

Set-top box, ADSL.

Switch, etc

IGMP1

Configuration Example

The following configuration example illustrates the steps required to create a static IGMP association. It assumes that vlan1 has already been configured as an IP interface on the switch.

1.Enable IGMP on the switch.

ENABLE IP IGMP

2.Enable IGMP on vlan1.

This must be done before the static IGMP association is created.

ENABLE IP IGMP INTERFACE=VLAN1

3.Create the static IGMP association.

The multicast data for the group specified by the DESTINATION parameter will be forwarded over the ports specified by the PORT parameter. If the PORT parameter is not entered, the association will default to all ports belonging to the interface.

CREATE IP IGMP DESTINATION=224.1.2.3 INTERFACE=VLAN1

PORT=1-4

4.Check the configuration.

Check that the static IGMP association has been created and IGMP is enabled.

SHOW IP IGMP DESTINATION=224.1.2.3 INTERFACE=VLAN1

Patch 86251-05 for Software Release 2.5.1 C613-10356-00 REV F

Page 25
Image 25
Allied Telesis 86251-05 manual Configuration Example