Installation

3.Next, connect a telephone line cable from the VDSL Line port to the wall/interior telephone line, as shown in Figure 22, so that the Provider unit can communicate with the Subscriber unit.

Powering On the Provider Unit

10100BBaasseeTTX/ LINK

ACT

PWR

LINE

AT-

 

 

 

 

ERR

MC601

VDSL

EXTENDED

MGMT

 

 

ETHERNET

PSTN

LINK

 

 

 

 

 

 

 

 

MCR1

2

AT-MC602VDSLEXTENDEDETHERNET

 

Wall/Interior Phone Line

Figure 22 VDSL Line to Wall/Interior Phone Line

Note

The procedure for connecting the management cable is described in ”Cabling Preparations” on page 36.

Powering on the AT-MC602 Provider Unit requires that the host equipment, AT-MCR12 rackmount chassis, is powered on as well.

Warning

The QUALIFIED SERVICE PERSONNEL must verify that the AT-MCR12 power cord is connected to the socket provided with the ground conductor.

If the power cord is not connected, the QUALIFIED SERVICE PERSONNEL must install a permanent ground connection using the bond stud on the rear panel of the AT-MCR12 chassis.

For detailed information on how to power on the AT-MCR12 unit, refer to the AT-MCR12 Media Converter Rackmount Chassis Installation Manual.

33