Configuration

The parameters on the Configuration screen are described below.

Upstream/Downstream

The upstream and downstream data transfer rate.

Actual (Mbps)

Displays the actual data transfer rate on the line. The software automatically detects this speed.

Min (Mbps)

Allows you to adapt the data transfer rate by setting a minimum speed.

Max (Mbps)

Allows you to adapt the data transfer rate by setting a maximum speed.

The maximum and minimum speeds in Mbps available in the pull-down menus are:

0.94

4.22

1.06

5.63

1.41

7.50

1.88

8.44

2.11

11.26

2.81

15.01

3.75

16.88 (upstream only)

Status

This field will display “Select speed to set” until you have selected data rates from the upstream and downstream pull-down menus and set the rates by clicking the Apply button. Then reports on the status of the attempt to configure the speeds selected from the upstream and downstream pull- down menus will appear in this field. A successful configuration attempt will cycle though the following status reports:

Looking for link status...

Checking signal/noise ratio

Loading a Configuration DS=1.41 US=2.81

(This report will keep repeating with progressively higher upstream and downstream values until the set rate or the highest possible rate has been achieved.)

Saving config on EEPROM - S Side Saving config on EEPROM - P Side Done

39

Page 39
Image 39
Allied Telesis AT-MC601 manual Upstream/Downstream, Actual Mbps, Min Mbps, Max Mbps, Status