Installation

 

Accessory List

 

• Head unit

1

• Power Supply box

1

• Power cable

1

• S video cable

1

• RCA extension cable (for video signal)

1

• Mounting sleeve

1

• Screw (M5 8)

4

Flange-head tapping screw (M4 14)

4

• Velcro Fasteners

2

• Front frame

1

• Remote Control

1

• Battery (CR2025)

1

• Carrying case

1

• Owner's Manual

1 set

Metal plate

 

Detachable

 

Front panel

 

Caution

When you install this unit in your car, do not remove the detachable front panel.

If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

1Mounting Sleeve

(Included) Dashboard

this unit

Slide the mounting sleeve into the dashboard.

2Screw

Hex Nut (M5)

*2

Bolt Stud

Metal

Mounting

Strap

*1

this unit

Ground Lead

Chassis

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle’s chassis.

For the screw marked “*2”, use an appropriate screw for the chosen mounting location.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the DVA-9965. Connect all other leads of the DVA-9965 according to details described in the CONNECTlONS section.

3

Lock Pin

Slide the DVA-9965 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the detachable front panel.

Removal

1 Remove the detachable front panel.

2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3 Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Front Frame

Screws (M5 8) (Included)

this unit

Ground Lead

*3

Mounting Bracket

Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis.

66-EN

Page 68
Image 68
Alpine DVA-9965 owner manual 66-EN, Accessory List, Slide the mounting sleeve into the dashboard, Removal, Japanese CAR