SETTING THE CLOCK
The GPS receiver used in this system is synchronized to the time data being transmitted by the GPS satellites. The satel- lites’ clock is Greenwich Mean Time (GMT). This is the worldwide standard for time. This makes the system’s clock very accurate once the appropriate time zone and daylight savings information is set.
To manually set the clock, change the time zone, or change daylight savings information, use a ballpoint pen or similar object to press the hour (H) or minute (M) buttons on the radio. The Setup screen appears.
•Setting the clock: Press the H button on the faceplate to change the hour or the M button on the faceplate to change the minute. The setting will increase each time you press the button. Holding either button in will fast- forward the setting. If no changes are made within 5 sec- onds of accessing the Setup screen, the screen will time out and you will be taken to the last mode.
42
NOTE: To reset the clock, select the appropriate time zone and press ENTER. The clock will revert to the accurate time based on the time zone you selected.
•Changing time zone: Highlight “Clock Setup” and press EN- TER. At the Clock Setup screen highlight the box next to “Time Zone” and press ENTER. High-
light the appropriate time zone for your location and press ENTER to store your selection. Select “Done” when fin- ished.
NOTE: When you are traveling and enter a new time zone, the clock must be reset manually for the new zone.
•Changing daylight savings: Highlight the box next to “Time” and press ENTER. Select “Daylight Savings” when Daylight Savings Time is in effect. Select “Standard” if Daylight Savings is not being observed. Press ENTER. Select “Done” when finished.
Select “Done” to exit from the clock setting mode.
