SECTION III
INSTALLATION PROCEDURES
Installation should be performed by competent technicians in accordance with local and state codes. In the absence of these codes, the installation must conform to applicable AMERICAN NATIONAL STANDARDS: National Fuel Gas Code
EDITION (for Electrical Connections)
A. REASSEMBLY OF DRYER
IMPORTANT: Always keep the tumbler (basket) section of the dryer in an upright position when moving it.
1.Reassembly Instructions for Dryer Shipped in Two (2) Pieces
In this method of shipment, the tumbler section and the tumbler base section are shipped as one unit and the heat console section is the second.
a.Reassemble Tumbler (Basket) and Tumbler (Basket) Base Section To The Heat Console Section
Move both pieces into position by lifting them with cables through the eyebolts located at the top of each of the two sections. These pieces may also be moved into place with a fork (lift) truck by lifting the pieces from underneath. The tumbler and tumbler base section weighs about 6,400 pounds (2,903 kg) and the heat console section weighs about 4,100 pounds (1,860 kg). Once the sections are in position, the seven
(7) clearance holes on the tumbler (basket) base section (four [4] in the front and three [3] in the rear) must be aligned with the seven (7)
b.Reattach The Control Pendant Arm
Position the control pendant arm to the top front of the heat console section by aligning the clearance holes in the arm with the
c.Reconnect The Internal Air, Electric Connections, and Water Connections (refer to page 12 through page 19)
8
