•The Proximity Sensor is located in the same area as the Tumbler Junction Box
•Inductive Proximity Mechanical Adjustment
•The target that is attached to the outside of the tumbler (basket).
•Stop motion detector module.
•Circuit wiring; refer to the
2b) If the L.E.D. (light emitting diode) is constantly “ON”
•If yes, the stop motion detector is defective.
•If no, check:
•Inductive Proximity Sensor for damage. The proximity sensor is located in the same area as the Tumbler Junction Box.
•Inductive Proximity Mechanical Adjustment.
•Tumbler (basket) target. This target is attached to the outside of the tumbler (basket).
•Stop motion detector module in the tumbler (basket) section on the left front side.
•Circuit Wiring; refer to the
•
81
