American Panel Corporation | American Panel AP20BC175-2 instruction

REV. C

REV. C

Cooler is Better!TM

USER’S

MANUAL

BLAST CHILLER / SHOCK FREEZER

MODEL AP20BC175-2

American Panel Corporation

5800 S.E. 78th Street, Ocala, Florida 34472-3412

Phone: (352) 245-7055 Fax: (352) 245-0726

E-mail:service@americanpanel.com

Image 1

American Panel AP20BC175-2 user manual American Panel Corporation, Rev. C, User’S Manual, Cooler is Better!TM

Contents

REV. C American Panel CorporationE-mail service@americanpanel.com USER’S MANUAL INSTALLATION INSTALLATION OF REMOTE UNITSUSING THE HURRICHILL TECHNOLOGY INDEX WIRING DIAGRAMS MAINTENANCE AND CLEANINGPARTS LIST STANDARD WARRANTY INTRODUCTION CONTROLLER FEATURESOPERATING MODES ADDITIONAL CYCLES OPERATING CYCLESPRINTER PC CONNECTION OPTIONAL REQUIREMENTS TO BE MET DURING INSTALLATION 8 STEPS INSTALLATION OF REMOTE UNITSINSTALLATION AT THE SAME LEVEL CONNECTION PIPING FOR REMOTE CONDENSING UNITS INSTALLATION AT DIFFERENT LEVELS INSTALLATION INSTALLATIONDIMENSIONS ELECTRICAL AND REFRIGERATION SPECIFICATIONS CONNECTION TO THE REMOTE UNIT VERIFYING CORRECT INSTALLATIONCONDENSATE DRAINAGE CONNECTION SPACES AROUND THE CABINET STARTING & TESTING THE UNIT BLAST CHILLING USING THE HURRICHILL TECHNOLOGYSHOCK FREEZING SOFT CHILL CYCLE PANNING PANNING AND LOADINGLOADING CONTROL PANEL FOR MODEL AP20BC175-2 BLAST CHILLER KEY COMBINATIONS KEYBOARD KEYSON/OFF & START/STOP PROGRAMMING KEYS 1. INITIAL PROGRAMMING PROGRAMMING The low air alarm temperature should be left at The high air alarm temperature should be left atThe high food alarm temperature should be left at The low food alarm temperature should be left at The printer baud rate should be left at The P.C. baud rate should be left at AUTOMATIC SOFT CYCLE PARAMETERS PROGRAMMING 2. PROGRAMMING THE CYCLES AUTOMATIC HARD CYCLE PARAMETERS PROGRAMMING p. To change the temperature, press DEFROST CYCLE PARAMETERS PROGRAMMINGthen press q. To change the temperature, press MANUAL SOFT CYCLE PARAMETERS PROGRAMMING MANUAL HARD CYCLE PARAMETERS PROGRAMMING 3. RECIPE NAME PROGRAMMING 1. AUTOMATIC MODE - SOFT CHILL OPERATION alternating 2. MANUAL MODE - SOFT CHILL 4. DEFROST CYCLE 3. HARD CHILL CYCLE b. Open the door PRINTER 5. PREPARING AND USING THE PRINTER6. TO CLEAR DATA LOADING A ROLL OF PAPER MAINTENANCEREMOVING A ROLL OF PAPER OPERATING THE PRINTER REPLACING THE RIBBON WITH PAPER IN THE PRINTER MAINTENANCE AND CLEANING CLEANING THE CONDENSER WIRING DIAGRAMSCLEANING THE STORAGE COMPARTMENT AP20BC175-2 Manual AP20BC175-2 Manual AP20BC175-2 Manual COMPUTER CONNECTION PART # PARTS LISTDESCRIPTION installing contractor. It is not covered by this Warranty STANDARD WARRANTYAMERICAN PANEL CORP 5800 S.E. 78th Street, Ocala, Florida ORDERING PRINTER SUPPLIES RIBBON & PAPER