Overview
14 Smart Distribution Panel with ATS
ATS panel board, right s ide
Input conductors from the mains connect to the
Source 1 input switch. See the InfraStruXure
Power Generation System Installation Manual
for connection instructions. WARN IN G: On ly
a certified electrician should connect power
to the ATS!
Behind this access panel are the Source 1 (S1
PT) and Output PT volt-sensing circuit boards.
Use a Phillips or standard screwdriver to
remove the panel.
The Source 1 current transformers monitor
the input current from each phase of the input
from the mains. The data gathered from these
current transformers is displayed on the Tota l
Load by Phase screen, accessed through the
Load Meter menu on the display interface.
Behind this access panel is the Source 2 volt-
sensing (S2 PT) circuit board. Use a Phillips or
standard screwdriver to remove the panel.
The Source 2 control transformer outputs AC
power to the Source 2 motorized switch. The
transformer steps down 400V input to the
120V required by the motor actuator.
Control power from Source 2 is supplied
through the Source 2 fuse block to the Source 2
control transformer and powers the Source 2
motorized switch.