Communication Configuration
56 Smart Distribution Panel with ATS
– LINUX command format:
ping 156.205.14.141 -s 113
3. Use Telnet to access the ATS at its newly assigned IP address. For example:
telnet 156.205.14.141
4. Use apc for both User Name and Password.
5. See “Control console” on this page to finish the configuration.
Control console
After you log on at the control console, as described in “Local access to the control console” on
page 55 or “Remote access to the control console” on page 55:
1. Choose Network from the Control Console menu.
2. Choose TCP/IP from the Network menu.
3. If you are not using a BOOTP or DHCP server to configure the TCP/IP settings, select the
Boot Mode menu. Select Manual boot mode, and then press ESC to return to the TCP/IP
menu. (Changes will take effect when you log out.)
4. Set the System IP, Subnet Mask, and Default Gateway address values.
5. Press CTRL-C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu).
Note
If you disconnected a cable during the procedure described in “Local access to the
control console” on page 55, reconnect that cable and restart the associated service.