42 Smart Distribution Panel with ATS
Stats
Statistics: 00 of 00
XX,XXXX
Reset Reset All
Name of statistic here
Scroll through a list of items that accumulate after the statistics record is reset, including:
•Open Xfer Count: The number of open transfers since this statistic was reset.
•Closed Xfer Count: The number of closed transfers since this statistic was reset.
•Generator Fuel Used: The amount of fuel used since this statistic was reset.
•Source 1 Bad Count: The number of times that Source 1 was not acceptable (as
defined in the Transfer Points menu) since this statistic was reset.
•S1 Low Volts Count: The number of times that the Source 1 input voltage went
below the configured Low voltage Transfer Point on one or more of the phases
since this statistic was reset.
•S1 High Volts Count: The number of times that the Source 1 input voltage
exceeded the configured High voltage Transfer Point on one or more of the
phases since this statistic was reset.
•S1 Bad Freq Count: The number of times that the Source 1 input voltage went
outside the configured Freq range (as defined in the Transfer Points menu)
since this statistic was reset.
•S1 Imbalance Count: The number of times that the percent voltage difference
between two phases, as defined by the Phase Balance setting in the Transfer
Points menu, has been exceeded on Source 1 since this statistic was reset.
•Total Time S1 Bad: The total amount of time that Source 1 was not acceptable
(as defined in the Transfer Points menu) since this statistic was reset.
•Maximum Time S1 Bad: The longest amount of time that Source 1 was not
acceptable (as defined in the Transfer Points menu) since this statistic was reset.
•Minimum Time S1 Bad: The shortest amount of time that Source 1 was not
acceptable (as defined in the Transfer Points menu) since this statistic was reset.
•Time on Source 1: The total amount of time that Source 1 was selected since this
statistic was reset.
•Time on Source 2: The total amount of time that Source 2 was selected since this
statistic was reset.
Reset Reset only the statistic that is shown on the screen by pressing the ENTER key and
following the prompts.
Reset All Reset all of the statistics by pressing the ENTER key and following the prompts.