AMT Datasouth 7200 manual Connecting the ATB Printer, Connecting to a Wall Receptacle

7200

2.1 Connecting the ATB Printer

This section explains how to connect the ATB printer to the power supply and the terminal.

2.1.1Connecting to a Wall Receptacle

A.Check that the power switch on the ATB printer is turned off.

Ferrite Core

B.Plug the power cable into the ATB printer. Then, plug the other end of the power cable into a wall receptacle.

Note!

Only use the supplied power cable. Ensure that the power cord complies with all local ordinances.

IMPORTANT...

The Ferrite Core must be attached to the AC Power Cord before the printer is connected to the wall receptacle. Failure to attach the Ferrite Core to the AC Power Cord may cause non-compli- ance to:

FCC Regulations for Class A computing device	Canadian ICES-003
EN55022-1 Class A Limits	EN50082-1
EN61000-3-2	EN61000-3-3
2-2	Operation Manual