7200
2.2 Turning the Power On and Off
After the ATB printer has been successfully installed and connected, turn on the power.
Note!
Turn on the terminal before turning on the ATB printer. Reverse the sequence when turning off the power.
Turn the power switch on.
The LCD panel displays the following three indicators in turn for specified intervals (a few seconds). Then, the ATB printer is set online.
When the power is turned on, the four LEDs are turned on as part of the self test routine.
ONLINE (OFF)
ONLINE
(ON)
S7200/PC94.03.08
S7200/08.30 Mecha.Type: D
CHECK-IN
or
TICKETING
LCD Test
ROM Version
(The display on the left is an example.)
Available Type
(The display on the left is an example.)
Modes
(The display on the left is an example.)
The ATB printer is checking itself.
This indicates the online status.
(Ticketing is enabled.)
The above is only an example. The actual displayed ROM value and available type
may be different from this example.
Operation Manual |
