7200
Bin and Cutter Blocks
Upper knob — for cleaning stock bin roller
Lower knob —
for cleaning cutter block roller
Head position of the cleaning sheet
The stock bin and burster rollers should be cleaned every 5000 documents or if printer performance degrades. The long, thin cleaning sheet is used for cleaning rollers, (not the card with the printed label which is used to clean the magnetic heads).
Avoid fire when
using isopropyl CAUTION alcohol to avoid the
risk of burning.
1.Uniformly apply a small amount of isopropyl alcohol to the long, thin cleaning sheet.
2.Insert the long cleaning sheet into the BIN 1 insert slot until it rests against the feed rollers.
3.Turn the red knob (labeled "1") counter- clockwise to pull the cleaning sheet into the document path until a resistance is felt.
4.Turn the blue knob (labeled "Forward")
5.To clean the BIN 1 feed rollers, hold the blue knob firmly while rotating the red BIN 1 knob clockwise for several turns.
6.To clean the burst rollers, hold the exposed cleaning sheet firmly with one hand while turning the blue knob counter- clockwise for several turns.
7.To remove the sheet, turn both the blue knob and the red knob clockwise until the sheet is returned to BIN 1.
To Clean BIN 2:
a)Repeat Steps 1 through 5, except, insert the cleaning sheet into the BIN 2 slot and turn the yellow knob (labeled "2") instead of the red knob.
b)To remove the cleaning sheet, follow Step 7, except, use the yellow knob instead of the red knob.
To Clean BIN 3:
a)Repeat Steps 1 through 5, except, insert the cleaning sheet into the BIN 3 slot (on the back of the printer) and turn the green knob (labeled "3") instead of the red knob.
b)To remove the cleaning sheet, follow Step 7, except, use the green knob instead of the red knob.
Operation Manual |
