AMX MVP-8400 manual Ethernet Only disabled when USB is selected

Setup Pages

Mode	Cycles between the connection modes: URL, Listen, and Auto.
	(Ethernet Only - disabled when USB is selected)
	• URL - In this mode, enter the IP/URL, Master Port Number, and username/
	password (if used) on the Master. The System Number field is read-only - the
	panel obtains this information from the Master.
	• Listen - In this mode, add the panel address into the URL List in NetLinx
	Studio and set the connection mode to Listen. This mode allows the Modero
	touch panel to “listen” for the Master’s communication signals. The System
	Number and Master IP/URL fields are read-only.
	• Auto - In this mode, enter the System Number and a username/password (if
	applicable). Use this mode when both the panel and the NetLinx Master are
	on the same Subnet, and the Master has its UDP feature enabled. The
	Master IP/URL field is read-only.
System Number
	Allows you to enter a system number. Default value is 0 (zero).
	(ETHERNET Only - disabled when USB is selected)
Master IP/URL
	Sets the Master IP or URL of the NetLinx Master.
	(ETHERNET Only - disabled when USB is selected)
Master Port Number
	Allows you to enter the port number used with the NetLinx Master.
	• Default = 1319
	(ETHERNET Only - disabled when USB is selected)
Username/Password
	If the target Master has been previously secured, enter the alpha-numeric string
	(into each field) assigned to a pre-configured user profile on the Master.
	This profile should have the pre-defined level of access/configuration rights.

Refer to the Step 3: Choose a Master Connection Mode section on page 31 for more detailed information on using the System Settings page.

86 MVP Modero ViewPoint Touch Panels