AMX MVP-8400 manual Removing the Installed Card, Installing the Compact Flash Upgrade Card

NXA-CFSP Compact Flash

B

Rear outer housing

Trim fits inside	A
the grooves around
the edges of the panel

Circuit board housing attachment locations (4)

FIG. 5 Removing the MVP enclosure (housing)

Battery Compartment cover

Housing screws

Bottom rim of outer housing

Panel

Removing the Installed Card

1.Discharge any static electricity from your body by touching a grounded metal object and then locate the card slot on the main circuit board (FIG. 6).

2.Place the circuit board on a flat level surface so that the IR Emitters are pointing away from you (FIG. 6).

3.Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either side of the existing card), and gently pry it out of the slot (FIG. 7). Repeat this process on the opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board connector pins.

4.Slip your finger into the gap between the card and the circuit board and firmly grab the card by its sides, then carefully pull it up and out of the slot. An angular removal of the card is required because one of the housing’s latch attachments blocks the slot opening.

use care when pulling up on the card.

Installing the Compact Flash Upgrade Card

1.Discharge any static electricity from your body by touching a grounded metal object and then locate the memory card slot on the main board (A in FIG. 6).

8 MVP-7500/8400 Modero Viewpoint Wireless Touch Panels