AMX MVP-8400 manual Following is a list of Intercom Commands

Programming

Intercom Commands

The following is a list of Intercom Commands:

Intercom Commands

^MODEL?	Panel model name. If the panel supports intercom hardware it will respond with its model
Sets model name.	name as shown in the response below. Older hardware or newer hardware that has inter-
	com support disabled with not respond to this command.
	Syntax:
	SEND_COMMAND <DEV>,"'^MODEL?'"
	Variables:
	None.
	Example:
	SEND_COMMAND TP1,"'^MODEL?'"
	Panel response string if intercom enabled:
	^MODEL-MVP-8400i
^ICS-	^ICS-<IP>,<TX UDP port>,<RX UDP port>,<initial mode>'"
Intercom start.	Intercom start. Starts a call to the specified IP address and ports. The initial mode is either
	1 (talk) or 0 (listen) or 2 (both). Please note, however, that no data packets will actually
	flow until the intercom modify command is sent to the panel.
	Syntax:
	SEND_COMMAND <DEV>,"'^ICS-<IP>,<TX UDP port>,<RX UDP
	port>,<initial mode>'"
	Variables:
	IP = IP Address of panel to connect with on an Intercom call.
	TX UDP port = UDP port to transmit to.
	RX UDP port = UDP port to receive from.
	initial mode = 0 (listen) or 1 (talk) or 2 (handsfree). 0 is the default.
	Examples:
	Example of setting up a handsfree Unicast call between two panels:
	SEND_COMMAND TP1,"'^ICS-192.168.0.3,9000,9002,2'"
	SEND_COMMAND TP2,"'^ICS-192.168.0.4,9002,9000,2'"
	Example of setting up a multicast call where the first panel is paging two other panels:
	SEND_COMMAND TP1, "^ICS-239.252.1.1,9000,0,1"
	SEND_COMMAND TP2, "^ICS-239.252.1.1,9000,0,0"
	SEND_COMMAND TP3, "^ICS-239.252.1.1,9000,0,0"
	Example of setting up a baby monitor call where the first panel is listening to the
	microphone audio coming from the second panel:
	SEND_COMMAND TP1,"'^ICS-192.168.0.3,9000,9002,0'"
	SEND_COMMAND TP2,"'^ICS-192.168.0.4,9002,9000,1'"
^ICE'	Intercom end. This terminates an intercom call/connection.
Intercom end.	Syntax:
	SEND_COMMAND <DEV>,"'^ICE'"
	Variables:
	None.
	Example:
	SEND_COMMAND TP1,"'^ICE'"
	SEND_COMMAND TP2,"'^ICE'"
	Terminates an intercom call between two panels.

MVP-7500/8400 Modero Viewpoint Wireless Touch Panels 139