Safety

Safety

Warning: Use the equipment on a flat surface.

Do not obstruct the equipment air outlets.

For indoor use only.

Do not attempt to service the equipment except to clean and replace the air filters. The equipment contains no other user-serviceable parts.

Do not place the rear of the equipment closer than 203 mm (8 in) to any wall or obstacle.

Do not install the equipment where there are fumes or flammable gases, or in an extremely humid space such as a greenhouse.

Do not place this equipment on its side. If the equipment has been tipped, place it upright on a flat, solid surface and keep it in this position for a minimum of 12 hours before operating.

Electrical Hazard: Connect the equipment to a 3-wire AC outlet (two poles plus a ground). The receptacle must be connected to a dedicated, properly grounded 115 volt 60Hz branch circuit rated for 20 amp main protection (fuses/circuit breaker). Connection to any other power source may result in a shock hazard or damage to the equipment.

Use the equipment with the supplied power cord only.

Do not use an extension cord.

Inspecting the Equipment

Your equipment has been tested and inspected for quality assurance before shipment. To ensure that the equipment has not been damaged during transit, carefully inspect both the exterior and interior packaging of the equipment immediately upon receipt.

Verify that all parts ordered were received as specified. See “Inventory” on page 4.

Filing a claim

If damage is identified on receipt of the equipment, note the damage on the bill of lading and file a damage claim with the shipping company. Contact APC for information on filing a claim with the shipping company. The shipping claim must be filed at the receiving end of the delivery.

Note: In case of shipping damage, do not operate the equipment. Keep all packaging for inspection by the shipper and contact APC customer support at one of the numbers listed on the back cover of this manual.

Storing the Equipment Before Installation

Caution: Leaving the equipment uncovered and exposed to the elements can cause damage and voids the factory warranty.

NetworkAIR ACPA4000

3

Page 11
Image 11
APC ACPA4000 manual Inspecting the Equipment, Storing the Equipment Before Installation, Safety, Filing a claim