APC ACPA4000 manual Accessories, Temperature/humidity sensor

Accessories

Temperature/humidity sensor

The Remote Temperature/humidity sensor (AP9512TH) monitors the room temperature and relative humidity. This remote sensor monitors the environment surrounding the cooling equipment to ensure that the conditioned air is cooling the desired area.

Note: The equipment cannot be controlled based on the temperature measured by the sensor.

To install the sensor:

1.Determine a location that allows you to neatly route and secure the 3.66-m (12-ft) cord near the heat source you want to control.

Note: Avoid locating the sensor in areas that could give you an inaccurate reading such as near air ducts, other heat sources, windows, direct sunlight, or room entrances.

2. Attach the sensor to a wall or other surface with the provided hook-and-loop fasteners.

3. Neatly route and secure the 3.66-m

(12-ft) cord with wire tie or cable clips.

4. Connect the sensor to the controller board at the rear of the equipment.

na0174a

12 NetworkAIR ACPA4000