APC ACPA4000 Drain Line, Connect the fitting to the drain line, Attach the drain line. Attach

Drain Line

The equipment contains an on-board condensate pump for automatic condensate removal.The equipment ships with 15.24 m (50 ft) of hose and a quick-connect fitting for removing condensate. You can attach a different hose to the equipment if you follow these requirements:

•You must use a 6-mm (1/4-in) outside diameter (OD), clear, polyurethane hose.

•The hose length must not exceed 15.24 m (50 ft), and 4.88 m (16 ft) vertical maximum.

•You must cut off all excess drain line and avoid kinking or pinching the drain line.

Connect the fitting to the drain line.

1.Insert the drain hose  through the capture nut .

2.Push the drain hose  over the barbs at the rear of the quick-connect fitting .

3.Screw the capture nut  onto the quick-connect fitting .

Attach the drain line. Attach

the connector end of the hose to the drain line connector on the rear of the equipment and run the hose to a drain.

Detach the drain line. Press the quick- release button on the top of the drain line connector and remove the hose.

Note: The equipment does not drain unless the drain line is installed.

na2658a

na0319a

NetworkAIR ACPA4000 11