APC AP9268 manual Connecting your Remote Peripherals, If you are using Remote PS/2 peripherals

Basic Installation

Connecting your Remote Peripherals

4.Plug a standard Category 5 Unshielded Twisted Pair cable (up to 500 feet) into the RJ-45 style modular jack on the rear of the APC KVM Switch. APC C5T or APC P5T cable is strongly recommended to achieve best performance and maximum distance. If you use a different Category 5 cable, make sure it is terminated to the EIA (TIA) 568 B standard, commonly used for 10BaseT Ethernet.

5.Route the Category 5 cable to the location where you intend to place the secondary monitor, keyboard and mouse.

6.If you are using Remote PS/2 peripherals

Place the Remote User Receiver near the monitor and connect your monitor, keyboard and mouse to the connectors on the rear of the Remote User Receiver (AP9279) just as you would connect them to your computer. Make sure you

connect your monitor’s power supply to appropriate electrical outlets. (Please

note that the connector on the rear of the Remote User Receiver is not

used in an APC KVM Switch configuration. Do not connect anything to the connector on the rear of the Remote User Receiver.)

5