APC AP9268 manual The Command Menu, APC KVM Switch, Add Channel

APC KVM Switch Installer/User Guide

4.3 The Command Menu

Once you have activated the main OSD Window, you can open the Command Menu by pressing either of the Control keys twice.

The Command Menu options are selected in the same manner as channels in the OSD Window. Scroll the Highlight Bar up and down and press Enter when your selection is highlighted.

APC KVM Switch

Configure Channel

Add Channel

Delete Channel

Change Channel Name

Change ChannelAddress

Dwell Time For ID window

Options For ID window

Alpha Scan Dwell Time

ENTER-accept ESC-previous

THE COMMAND MENU

If you are operating in non-secure mode or are the system administrator, you will have several options that do not appear in the User level Command Menu: Add Channel, Edit Channel, Delete Channel and Administrator Functions are all covered in separate sections in this chapter. Scanning is covered in Chapter 6.

If you experience a loss of mouse signal while using the APC KVM Switch, select the ‘Reset PS/2 Standard Mse/Kbd’ option from this menu for a PC with a standard mouse driver or ‘Reset PS/2 Wheel Mse/Kbd’ if you are using a PC with a Microsoft IntelliMouse or other wheel mouse driver. This will reset and in most cases restore your mouse signal. These commands are equivalent to the <CM>MR<Enter> and <CM>MW<Enter> keyboard command listed in the ‘System Control & Maintenance’ section of this manual.

Choose the option ‘Version Information’ to display on your monitor the current version level of your APC KVM Switch firmware. Press the Esc key to clear this information from your screen.

16