MODULE #3 - PROGRAM FUNCTIONS ACCESSIBLE W/ FRONT PANEL LOCKOUT
This programming module programs what is accessible through the front panel when the PGM. DIS. pin is connected to common (COMM.).
Note: The term “Quick Programming” is used to refer to the ability to change the information that can be accessed from the front panel when the “PGM. DIS.” terminal is connected to “COMM.”.
DISPLAY ALARM VALUES
If the alarm option is installed, this selects whether the alarm values will or will not be displayed.
“dSP AL” < > “yES” or “NO”
ENTER ALARM VALUES
If “YES” was selected for display alarm values, this will select if alarm values may be modified from the front panel. (If “NO” was selected for display alarm values, then this step will default to “NO” and will not be displayed for selection.)
“ENt AL” < > “yES” or “NO”
DISPLAY HYSTERESIS VALUES
If the alarm option is installed, this selects whether the hysteresis values will or will not be displayed.
“dSPHYS” < > “yES” or “NO”
ENTER HYSTERESIS VALUES
If “YES” was selected for display hysteresis values, this selects whether hysteresis values may be modified from the front panel. (If “NO” was selected for display hysteresis value, then this step will default to “NO” and will not be displayed for selection.)
“ENtHYS” < > “yES” or “NO”
RESET LATCHED ALARMS
If the alarm option is installed and if either alarm is programmed to latch, this will select if a latched alarm(s) can be reset from the front panel.
“rSt AL” < > “yES” or “NO”
DISPLAY PEAK/VALLEY MEMORY BUFFER
If the integrator/totalizer option is installed, this selects whether peak and valley buffers will be displayed.
“dSPbUF” < > “yES” or “NO”
RESET PEAK/VALLEY MEMORY BUFFER
If “YES” was selected for the previous step, this selects whether the peak and valley buffers may be reset from the front panel. (If “NO” was selected, then this step defaults to “NO” and will not be displayed for selection.)
“rStbUF” < > “yES” or “NO”
SELECT DISPLAY*
If the integrator/totalizer option is installed, this selects whether the display can be switched from input display to total display and from total display to input display.
Note: When “NO” is selected, whatever display (Input or total) is shown, will be the only display accessible.
“SELdSP” < > “yES” or “NO”
RESET TOTAL*
If the integrator/totalizer option is installed, this selects whether the total can be reset from the front panel.
“rSttOt” < > “yES” or “NO”
Note: This sequence may be
