Apollo IMY instruction manual Appendix D Programmable Functions Cont’d

APPENDIX “D” - PROGRAMMABLE FUNCTIONS (Cont’d)

“Pro 5” - PROGRAM INTEGRATOR/TOTALIZER

“dECPNt”	-	Enter decimal point for totalizer
“tbASE”	-	Enter time base
0	-	second
1	-	minute
2	-	hour
“SCLFAC”	-	Enter multiplying scale factor
“Lo-cut”	- Enter low-signal cut out
“Pro 6” - PROGRAM ALARMS
“trAc”	-	Enable alarm value tracking
“dISP”	-	Enable display alarm annunciators
“LAtC-1”	-	Enable alarm #1 latching
“ASN-1”	-	Enter alarm #1 trigger source ( temp. or integrator/ total)
“AL-1”	-	Enter alarm #1 value
“HYS-1”	-	Enter hysteresis value for alarm #1
“Act-1”	-	Enter alarm #1 action (high or low)
“LAtC-2”	-	Enable alarm #2 latching
“ASN-2”	-	Enter alarm #2 trigger source ( temp. or integrator/ total)
“AL-2”	-	Enter alarm #2 value
“HYS-2”	-	Enter hysteresis value for alarm #2
“Act-2”	- Enter alarm #2 action (high or low)

“Pro 7” - PROGRAM SERIAL COMMUNICATIONS

“bAud”	-	Enter baud rate
“AddrES”		Enter loop address number (0-99)
“Print”	-	Enter print function, or “P” command function through
	-	Serial Option
0	-	temp.
1	-	temp.,	peak/valley, and offset
2	-	temp. and alarms
3	-	temp, peak/valley, alarms, hysteresis, and offset
4	-	total
5	-	temp. and total
6	-	temp.,	total, peak/valley, and offset
7	-	total and alarms
8	-	temp.,	total and alarms
9	-	temp.,	total, peak/valley, alarms, hysteresis, and offset
“FULL”	-	Enable complete or abbreviated printing
“Pro 8” - PROGRAM RE-TRANSMITTED ANALOG OUTPUT
“ASIN”	-	Select source of analog output (input or total)
“AN-Lo”	-	Enter 4 mA or 0 VDC display value
“AN-HI”	-	Enter 20 mA or 10 VDC display value

“Pro 9” - SERVICE OPERATIONS (Protected by access codes)

“Code 39” - Serial hardware (loop-back) test “Code 48” - Basic input calibration

“Code 66” - Reset programming to factory configuration

-43-