Apollo IMY instruction manual Appendix D Programmable Functions, Decimal Point Positon

APPENDIX “D” - PROGRAMMABLE FUNCTIONS

Programming of the indicator is divided into modular steps. Each module is a short sequence of data entries. The front panel buttons “UP” and “DOWN” (shown as “arrows” on the front panel) are used to change the data and set-ups, while the “P” button is used to save or enter the data. After pressing “P”, which gains entry into the programming mode, the programming modules are identified by the message “Pro” and a number in the display. “UP” and “DOWN” are used to select the desired programming module and “P” is used to enter it. All of the subsequent programming steps follow the same procedure. The rear terminal labeled “PGM. DIS.” must be ungrounded to gain access to programming. The following table lists the programming steps.

“Pro 0” - RETURN TO MEASUREMENT MODE

“Pro 1” - PROGRAM THERMISTOR TYPE, TEMPERATURE SCALE

AND DECIMAL POINT POSITON

“tYPE”	- Select thermistor type (400/700)
“SCALE”	-	Enter either degree (F or C)
“dECPNt”	-	Enter resolution (0 or 0.0)

“Pro 2” - PROGRAM TEMPERATURE SLOPE AND OFFSET

“SLOPE” - Enter display slope (0.0001 to 9.9999) “OFFSEt” - Enter offset (-999 to 9999)

“Pro 3” - PROGRAM FUNCTIONS ACCESSIBLE WITH FRONT PANEL LOCKOUT ENGAGED

“dSP AL”	-	Enable display alarms
“ENt AL”	- Enable enter alarms ￿
“dSPHYS”	-	Enable display hysteresis
“ENtHYS”	- Enable enter hysteresis ￿
“rSt AL”	- Enable reset latched alarms
“dSPbUF”	- Enable display of peak/valley readings
“rStbUF”	- Enable reset of peak/valley readings￿
“SELdSP”	- Enable switching display between input and total
“rSttOt”	-	Enable reset total
“dSPOFF”	- Enable display offset value
“ENtOFF”	- Enable enter offset value ￿

“Pro 4” - PROGRAM DIGITAL FILTERING AND REMOTE INPUT FUNCTION

“FILter” - Enter level of digital filtering

0- no digital filtering

1- normal filtering

2- increased filtering

3- maximum filtering

“E1-CON” - Enter function of remote input

0- offset input to zero

1- reset total

2- reset and gate totalizer

3- gate totalizer

4- display hold

5- reset peak/valley

6- reset peak and start peak indicator

7- reset valley and start valley indicator

8- reset latched alarms

9- reset all alarms

10- toggle display between input and total

11- offset input to zero and totalizer the offset values

12- display hold with tare

13- instrument reading with synchronization

14- print request

“E2-CON” - same functions as E1-CON

￿This sequence may be subject to being locked-out due to other programmed sequences.

-42-