Process Controlling System | Apollo IMY guide

PROCESS CONTROLLING SYSTEM

Six Model IMYs with Serial Communication Option are used to monitor and control the temperature of 6 ovens at a large bakery. The IMYs are located at each of the ovens in the production area of the building. The communications lines are run to an industrial computer located in the production offices.

The drawing below shows the Current Loop set-up. Each IMY is given an address and programmed accordingly (Program Module #7). A baud rate of 1200 is selected.

An application program is written, which sends and retrieves data from the IMYs.

Note: On all IM indicators, the SO+ and the +20 mA SRC are connected internally. Therefore it is not necessary to have this terminal tied to any other terminal on the unit if that unit is serving as the loop supply source.

-32-

Image 34

Apollo IMY instruction manual Process Controlling System

Contents

Apollo Intelligent Meter Series Introduction Table of Contents Page Safety Summary Safety InformationDefinition of Terms General Description Theory of Operation Block Diagram Programming and Operating the IMY Programming the IMY Display Module #2 Program Temperature Display Offset and Slope Reset Latched Alarms Display Alarm ValuesEnter Alarm Values Reset PEAK/VALLEY Memory Buffer Temperature Offset Value Enter Offset Value Module #4 Program Digital Filter and Remote Input Program Digital Filtering Program Function of E1-CON and Optional E2-CON Cont’d Program Decimal Point Position for the INTEGRATOR/TOTALIZER Module #5 Program INTEGRATOR/TOTALIZERProgram INTEGRATOR/TOTALIZER Time Base Module #6 Program ALARM/SETPOINT Program Value for Alarm #2 Alarm #2 Assignment to Input or INTEGRATOR/ TotalizerAlarm #2 High or LOW Acting Print Request Function Baud RateUnit Address Number Full or Abbreviated Transmission Analog Output LO Display Value Module #8 Program RE-TRANSMITTED Analog OutputAnalog Output Source Analog Output HI Display Value Enter Zero Reference Module #9 Service OperationsEnter Access Code Apply Precision Resistance Operating the IMY Quick Programming Factory Configuration Slope Programming Example Temperature Monitoring Example INTEGRATOR/TOTALIZER Offset and Slope Display TemperaturePEAK/VALLEY Basic SET-UP INTEGRATOR/TOTALIZER ExampleINTEGRATOR/TOTALIZER SET-UP 125 x 827 Alarms Optional Alarm Timing Diagrams General Description Communication Format Sending Commands to the IMY Command String Examples Timing Diagrams Receiving Data from the IMY Current Loop InstallationWiring Connections Serial Terminal Descriptions Connecting to AN RLC Printer Serial Communications Examples Process Controlling System RE-TRANSMITTED Analog Output Optional Analog Output Calibration To 20 mA Calibration Installation Environment Appendix a Installation & ConnectionsSelect AC Power 115/230 VAC EMC Installation Guidelines Wiring Connections Power Wiring Appendix B Specifications and Dimensions Open Thermistor Detection Display Ululul To 20 mA Certifications and Compliances Safety Appendix C Troubleshooting Guide Problem Possible Cause Remedies Appendix D Programmable Functions Decimal Point Positon Appendix D Programmable Functions Cont’d Appendix E Ordering Information E2-CON Limited Warranty IMY/IM-A 3/02 Drawing NO. LP0311