4. Steering

- Check that the handlebar and stem enable correct steering and are properly adjusted and tightened

-Check that the setting of the handlebars is correct in relation to the forks and the direction of travel

-Check the head set locking mechanism is appropriately fixed and fastened

-If handlebar extensions are fitted check they are positioned and secured correctly

-Ensure the minimum insertion mark cannot be seen on the handlebar stem

-Ensure the ends of the handlebars and bar ends are covered or capped.

5. Chain

-Check the chain is lubricated, clean and runs freely

-In wet or dusty conditions service the chain more frequently

6. Bearings

-Check headset, wheel bearings, pedal bearings and bottom bracket bearings

-Check all bearings are oiled, run smoothly and show no signs of excess movement, grinding or rattling

7. Cranks and Pedals

-Check cranks are securely fastened to the axle and are straight

-Check pedals are properly and firmly attached to the crank

8. Derailleurs

-Check the front and rear mechanisms are operating appropriately

-Check control levers are securely anchored

-Check derailleurs, control cables and shift levers are sufficiently lubricated

-If the gear components come with a separate, specific manual, refer to this for further information

9. Frame and fork

-Check that the frame and fork are straight and intact.

-Replace if either is bent or broken.

10. Suspension (if applicable)

-Check that components operate smoothly with no binding. Keep clean of grit, and lubricate top of outer leg seal.

-Check that all components of the fork & rear suspension are properly tightened

-Check the rear suspension components for excessive wear or side play

-If the suspension components come with a separate, specific manual, refer to this for more in depth information

13

Updated 23/05/07

RAOM0507

Apollo Bicycle Company Pty. Ltd. ABN: 60 001 914 469

Page 15
Image 15
Apollo Radius manual Updated 23/05/07 RAOM0507