C H A P T E R 2
LaserWriter Select 310 Software
Changes in Font Cache Operation
Operation of the font cache has changed in the LaserWriter Select 310 printer. Formerly, there was a single limit on the number of bytes occupied by a character in the cache. Any character larger than the space allocated would not be cached. Now there are two cache thresholds, a lower and an upper threshold. The following cache conditions apply:
■if the character is larger than the space allocated by the upper threshold, as determined by the bounding box specified to setcachedevice, the character will not be cached
■if the character is larger than the lower threshold, it will be compressed and cached
■if the character is not larger than the lower threshold, it will be stored as a full pixel array
The two thresholds are manipulated by the new operators setcacheparams and currentcacheparams. These operators are described in detail earlier in this chapter, in the section “Setting Extensions to PostScript Level 1.” The old operators, cachestatus and setcachelimit, remain valid, although they will rarely be used.
Compressed characters consume much less space in the font cache than the full pixel arrays, by factors of up to 40. However, more computation is required to reconstitute them when they are needed. Reconstituting a compressed character is still considerably faster than
In systems such as the LaserWriter Select 310 printer which prints at 300 pixels per inch (dpi) or less, the default lower threshold is set so that characters up to about 20 points are stored as full pixel arrays, while larger ones are stored in compressed form. This means that ordinary body text may be cached using the
array representation, but large characters will be cached using
Device Resolution Images
A large class of sampled images is now transferred directly from a binary source image to the raster output device rather than using the more general sampling and halftoning technique. The conditions for the image operator’s fast case are now as follows:
■The image is one bit per sample.
■Image and device resolutions are the same. This means that the combination of
the image matrix and the current transformation matrix is such that one unit in image space corresponds to one unit in device space.
■The image coordinate systems x and y axes are either parallel to or perpendicular to the corresponding axes of the device space. This expands the fast case to include rotations of 0, 90, 180 and 270 degrees, as well as their x and y reflections, to provide a total of eight different image orientations, instead of the two previously allowed.
If an image that meets the above conditions on the LaserWriter Select 310 printer is printed on an earlier PostScript printer, it may be treated as a general image. In this case, the earlier printer may process the image more slowly than the LaserWriter Select 310 printer, but the results will still be correct, preserving the device independence of the PostScript language page descriptions.
42 | PostScript Language Changes |
