One Memory Card on RamKeeper

If you want to attach only one card to the RamKeeper, you will, in most cases, want to plug it into the Back Pocket™. This keeps slot 7 clear.

Use the drawing below to help you determine if you can use the Back Pocket for your card or, if not, which connector you'll need to connect it to the front side of the RamKeeper.

Slot Mover

RamKeeper

Back Pocket

 

All GS-RAM cards

 

GS-RAM REV C or later

(including 2 Meg Expander)

GS-RAM Plus REV 0 or later

Apple IIGS Memory Expansion Card

GS-RAM 2 Meg Expander

RamPak 4GS

 

Apple IIGS Memory Expansion

Card

 

RamPak 4GS

RamStackPlus

Front Connector

RamStackPlus

OnBoard

OnBoard

OctoRam

All GS-RAM cards

* Due to its large size,

 

(except 2 Meg Expander)

OctoRam will not fit on the

 

 

back side of RamKeeper

Single Card Options

*GS-RAM Note: GS-RAM REV A and GS-RAM Plus REV A cards require the optional SlotMover to keep slot 7 clear. The REV A cards have the silver pins extending from the black connector on the back side of the card just above the edge connector. If placed in the back pocket, these pins keep the card from fitting properly between the RamKeeper and the right side of the IIGS case. Although it is possible to cram the REV As into the Back Pocket, the pins may hit the metal of the computer case and short out the board(s).

*OctoRam Note: Due to its large size, OctoRam will not fit on the back side of RamKeeper. If you're connecting an OctoRam to the front side of the card, the last two memory rows must be empty. So, if you’re using 256K chips, you can only have 1.5 Meg of the card filled, If you’re using I Meg chips, you can have only 6 Meg filled.

2 RamKeeper