To install the RamKeeper, you'll need a Phillips screwdriver. Once you have it, follow the steps below:
1.) TURN OFF THE APPLE’S POWER SWITCH. Never install or remove a card while the computer is on. However, you need to leave the computer plugged in throughout the installation to allow the power supply to discharge static electricity from your body.
2.) Remove the cover from the Apple. Press in the two latches in the rear of the case with your forefingers while using the heel of your hand to pull the lid up and towards you. (See below.)
3.) Touch the power supply to remove any static electricity from your body. Do not skip this step! A static shock can damage the chips on your boards and/or the chips on your computers motherboard.
Remove the IIGS cover | Touch the power supply case |
4.) You may want to remove any cards in slots 6 and 7 to give yourself a little more room to operate. If you do remove any cards, follow the instructions that came with those cards for removing and reinserting. Applied Engineering will not be responsible for any damage to your other cards.
Chapter One - Getting Started 5