Analogue Video
This setting controls the type of video given out on the Component and SCART video outputs. It is set at the factory to be appropriate for the type of display device used in your country, so it is best not to change it. If it gets set incorrectly then the picture shown on the display device will have strange colouring.
Component The video output on the Component video (3 phonos), SCART and HDMI connections is Y, Pb, Pr component video.
RGB SCART The video output on the Component video (3 phonos), SCART and HDMI connections is RGB. Note that if you are using RGB output via phono connectors, you will also need to use COMPOSITE as a sync. signal.
Note that this setting has no effect on the video provided by the HDMI connector.
Digital Video
This setting controls the type of video given out over the HDMI connection.
YUV | The HDMI connection carries Y, Pb, Pr (YUV) component video. |
RGB SCART The HDMI connection carries RGB video.
Note that this setting has no effect on the analogue video outputs.
NTSC black (Pedestal)
This setting controls the ‘pedestal’ signal or black level when the NTSC video standard is used.
0 IRE | This removes the pedestal from NTSC video. This setting should be used in Japan, |
| and also if you are using RGB video, whatever the country. |
7.5IRE This is the standard pedestal level that should be used in all countries that use NTSC video, with the exception of Japan.
Note that this setting has no effect on PAL, progressive scan or HDMI outputs.
English
Audio set-up
This section allows you to configure the type of analogue and digital audio outputs. In particular, the digital output type needs to be set correctly if you are using an external audio decoder, receiver or
Audio
Two different types of digital output are supported: ‘Bitstream’ and ‘Stereo PCM’.
Bitstream The Bitstream setting supports the following audio standards:
n 2 channel PCM (on CDs or DVDs) n Dolby Digital
n MPEG multi channel n DTS multi channel
Use the Bitstream setting if you have an external decoder that supports Dolby Digital.
Stereo PCM When the ‘Stereo PCM’ digital output is selected, all audio material played is
���������
��������������������
�������� �������
����������� �������
����������� ���
����������������� �����
������������� �
���������������� �
������������ ���
Since the digital and analogue outputs are closely related, the analogue audio output reflects the digital output type selected.
The options available are as follows:
Bitstream + The digital output is ‘Bitstream’ (as described above). The analogue audio will
6 Ch. comprise up to six channels of output, depending on the source material, the speaker configuration (see the ‘Speaker Setup’ section) and the ‘Pro Logic II’ setting (see below).
Bitstream + The digital output is ‘Bitstream’ (as described above). The analogue audio will
2 Ch. comprise a
PCM + 2 Ch. The digital output is ‘Stereo PCM’ (as described above). The analogue audio will comprise a
Language
This controls the default audio track, when there is more than one audio track present.
The default setting is ‘English’. Choose the setting you would like as default. Note that the audio- language preference setting is not respected by all discs, which may impose their own default choice.
Down-sample
This needs to be set correctly if you are using an external audio decoder, receiver or
Max 96K Choose this option if your external audio decoder is able to process digital audio with a sample rate of up to 96kHz, or if you are not using the digital audio outputs. This is the maximum sample rate present on
Max 48K Choose this option if your external audio decoder is unable to process digital audio with a sample rate of up to 96kHz, or the HDMI connection is being used to carry the audio.
Note that this setting is relevant only to the output from
DV79
