.

2

3

1

2

1

3

4

1.Chute Crank

2.Control Panel

3.Pinion Gear

4.Spring Clip Pin

Figure 7

OS2535

 

OS2536

Install Remote Deflector Cable

(Figure 8 and 9)

1.Slide cable through clip on top of discharge chute pedestal Figure 8.

2.Bend clip closed around cable.

3.Using the wire hook attached to the deflector cable, hook cable to discharge chute crank.

5

4

1.Remote Deflector Cable

2.Remote Deflector Control

3.Cable Clip

4.Wire Cable Hook

5.Cable Mounting Bracket

Figure 8

4.Pull rubber seal cap away from snap fitting.

5.Install snap fitting into cable bracket’s upper mounting hole.

NOTE: The cable mounting bracket located underneath the control panel contains two mounting holes. Use only the upper mounting hole; the one closest to the dash.

6.Position rubber seal cap over the top of snap fitting.

7.Move deflector control lever to forward most position.

8.Attach cable eye to pin on bottom of deflector control lever.

NOTE: Hold down chute deflector cap, if needed, for more cable slack.

9.Secure cable eye to control lever with washer and hairpin.

10.Test controls to be sure deflector works properly.

NOTE: If deflector does not follow full range of travel See Remote Discharge Deflector Control Adjustment on page 21.

GB - 10