With the attachment clutch disengaged, check the attachment idler arm position here. The attachment idler arm should lightly touch the frame.
1. Attachment Idler Arm |
Figure 30 | OS7188 |
|
1.Place the unit into the service position (see Service Position on page 18). Remove the bottom cover.
2.With the clutch lever engaged, check the clearance between the frame and plastic roller on the lower end of the attachment idler arm. See Figure 31.
•If roller is 1/2 – 7/8 in. (12.7 –
22.2 mm) from frame, go to Adjust the
Attachment Clutch Cable Spring
Extension on page 26.
•If roller is less than 1/2 in. (12.7 mm) from frame, loosen idler adjustment nut and move idler closer to the belt. Tighten adjustment nut and recheck the roller clearance.
•If roller is more than 7/8 in. (22.2 mm) from frame, loosen idler adjustment nut and move idler away from the belt. Tighten adjustment nut and recheck roller clearance.
Roller should be 1/2 – 7/8 in. (12.7 –
22.2mm) from the frame when the attachment clutch is engaged.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Figure 31 |
|
| |||||||||||||||
|
|
|
| OS8080 | |||||||||||||||||||||||||||
1.Check the attachment clutch cable spring extension.
Measure the length of the attachment clutch cable spring with the clutch lever disengaged.
Then measure the attachment clutch spring with the clutch lever engaged. See Figure 32. The spring should be 1/2 – 9/16 in. (12.7 – 14.3 mm) longer when the clutch lever is engaged.
•If spring extension is within the specified range, go to Check Attachment Brake on page 27.
•If spring extension is outside of specified range, go to step 2.
1/2 – 9/16 in. (12.7 – 14.3 mm)
Figure 32 | OS8085 |
GB - 26