1

1.

Swing Gate Spacer

2

2.

Drive Plate

 

 

Figure 27

OS2630

 

2

 

3

 

 

 

1.

Swing Gate

1

 

 

 

2.

Swing Gate Finger

 

3.

Drive Plate

Figure 28

 

 

 

OS8068

5.Pull idler away from traction drive belt and remove belt from idler, drive pulley and driven pulley.

6.Replace traction drive belt.

7.Swing drive plate toward friction disc to slide finger into stop hole in frame. Reinstall swing gate spacer.

NOTE: Make sure drive plate spring remains connected to the frame and drive plate.

8.Replace attachment drive belt (See Replace Attachment Drive Belt on page 24).

ATTACHMENT CLUTCH/BRAKE ADJUSTMENT

WARNING: IMPROPER

ADJUSTMENT could result in unexpected movement of auger and impeller causing death or serious injury. AUGER / IMPELLER MUST STOP within 5 seconds when Attachment Clutch/Impeller Brake Lever is released.

Remove Attachment Cable Slack

1.Loosen the hardware securing belt cover to unit.

NOTE: DO NOT completely remove the hardware from unit.

1.Remove the belt cover.

2.Loosen jam nut (3) on cable adjustment barrel (2), and then turn the adjustment barrel down to shorten cable and remove all cable slack. See Figure 29.

1

2

3

1.Attachment Clutch Cable

2.Cable Adjustment Barrel

3.Jam Nut

Figure 29

OS2645

3.With the attachment clutch disengaged, check that the attachment idler arm lightly touches the frame. See Figure 30.

4.Tighten jam nut on cable adjustment barrel.

GB - 25