Position the Speed Selector in the appropriate speed notch to control forward and reverse travel.
6 | 1 | 1 | 2 |
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ForwardReverse
(6) | Fastest | (1) | Slow |
(1) | Slowest | (2) | Fast |
OS2581
IMPORTANT: DO NOT change motion from forward to reverse with clutch engaged. Forward speed can be changed without declutching.
SnowFigure 11
WARNING: Hand contact with the rotating impeller is the most common cause of injury associated with snow throwers. Never use your hand to clean out the discharge chute.
1. Snow
Figure 11 | OS2550 |
|
To clear the discharge chute:
1.Move PTO and power switches to OFF position. Remove key.
2.Wait 10 seconds and make sure impeller blades have stopped rotating.
3.Remove the snow
4.Replace the snow
ALWAYS position discharge chute deflector at a safe angle before engaging the auger.
Place deflector into position before operation. DO NOT throw snow any higher than necessary.
Place deflector remote in a forward notch to throw snow lower. Place deflector remote in a rearward notch to throw snow higher
Discharge ChuteDischarge chute rotates 200°.
ALWAYS position discharge chute in safe direction and angle, away from operator and bystanders, before engaging auger.
Discharge Chute CrankIMPORTANT: If chute does not stay in set position, adjust as directed in SERVICE AND ADJUSTMENTS on page 20, or repair before operation.
Rotate the chute with the discharge chute crank handle.
IMPORTANT: DO NOT force frozen chute controls. If frozen, take to warm place until controls are free.
Axle Lock PinFigure 12
Use the axle lock pin to lock or unlock the right or left wheel. Lock both wheels to increase traction; unlock one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
GB - 14