TROUBLESHOOTING

PROBLEM

PROBABLE CAUSE

CORRECTION

Unit throws snow

1.

Shear bolts broken.

1.

Replace shear bolts (see Shear

poorly or does not

 

 

 

Bolts on page 21).

throw snow.

 

 

 

 

 

2.

Attachment clutch/brake

2.

Adjust attachment clutch/brake

 

 

not adjusted properly.

 

(see Attachment Clutch/Brake

 

 

 

 

Adjustment on page 25).

 

3.

Auger is frozen in place.

3.

Move unit to a warm place to

 

 

 

 

thaw.

 

4.

Ice or debris is obstructing

4.

Move PTO and key switches to

 

 

auger.

 

OFF position. Remove key from

 

 

 

 

switch. Clear blockage from

 

 

 

 

auger or chute (see Snow Clean-

 

 

 

 

Out Tool on page 14).

 

5.

Attachment drive belt

5.

Adjust or replace attachment

 

 

slipping, worn or damaged.

 

drive belt (see Attachment

 

 

 

 

Clutch/Brake Adjustment on

 

 

 

 

page 25).

Controller displays

1.

A trouble code has been

Perform the suggested correction. If

flashing red light

 

set in the electrical system:

trouble code resumes contact your

under the cover.

 

____ = long flash

Ariens Dealer.

 

 

• = short flash

 

 

Controller

 

 

Code:

 

 

1.

____ •____•

1.

Turn key to OFF position, allow

 

(Motor Coil Overheated)

 

unit to fully cool before resuming.

2.

____ • •____• •

2.

Contact your Ariens Dealer.

 

(Motor Position Error)

 

 

3.

____ • • •____• • •

3.

Turn key to OFF position, allow

 

(Controller Overheated)

 

unit to fully cool before resuming.

4.

____ • • • •____• • • •

4.

Charge batteries (see Low

 

(Low System Voltage)

 

Battery Voltage on page 17).

5.____ ____• •____ ____• • 5. Move PTO and key switches to

(Stall Mode)

OFF position. Remove key from

 

switch. Clear blockage from

 

auger or chute (see Snow Clean-

 

Out Tool on page 14).

 

NOTE: Unit must be OFF for a

 

minimum of 30 seconds before

 

resuming.

GB - 30