Manuals / Aruba Networks / Computer Equipment / Network Router

Aruba Networks Aruba AP 60/61 manual Manual Provisioning, Requirements

Models: Aruba AP 60/61

1 68

Download 68 pages 32.7 Kb

Page 16

Provisioning Access Points

Chapter 2

If the entry does not show up in the AP list, check network connectivity. Go to the AP console and verify if the AP has come up with the IP from the provisioning subnet.

8.After the entry shows up on the page, configure the location, Host IP/Name, Master IP address.

If AP is going to be assigned a static IP, click Use the following IP Address and enter the IP address, Netmask, Gateway IP.

If the AP is going to obtain an IP address using DHCP, click Use IP Address Using DHCP.

9.After configuring the required parameters, select the entry from the list (AP to which the configuration has to be applied) and click Apply.

The State field changes from U (Unprovisioned) to In Progress. to P (Provisioned).

NOTE: Check that the configured parameters are reflected in the AP list entry.

NOTE: Aruba Networks recommends that you provision each AP for a unique location as suggested by site-survey planning. Label each AP with this location information and place the AP in its proper location. Failure to place APs in the location for which they were provisioned will reduce the effectiveness of such RF features as triangulation.

10.Click Back to return to the previous page

We can see that the Subnet is still configured and Port/s are selected.

11.When finished provisioning APs, click Disable to disable AP Provisioning.

NOTE: Disable AP Provisioning after all the required APs are provisioned. Ports that are enabled for provisioning do not handle traffic. Therefore plugging an already provisioned AP into a port still set to provisioning mode will prevent that AP from functioning.

Now the AP is configured with the Parameters given

12.Reboot the AP so the AP will come up with the new configured parameters.

Use the Reprovisioning tab for APs which are already deployed but need to be reconfigured. See the ArubaOS User Guide for information on reprovisioning.

Manual Provisioning

Requirements

zA console terminal (or workstation with terminal emulation software) with an available serial communications port using a DB-9 male connector.

12 Aruba AP 60/61	0500160
Installation Guide	December 2005

Image 16

Aruba Networks Aruba AP 60/61 manual Manual Provisioning, Requirements

Contents

Aruba AP 60/61 Access Point Aruba Wireless Networks, Inc. All rights reserved TrademarksContents Appendix B Port Specifications Introduction1 Antenna fixtures for Wireless Communications Front ViewIndicator LEDs 1Aruba AP 60/61 LEDsState Description Air VentsDC Power Socket FE PortBack View Mounting SlotsFold-Out Stand Aruba AP Setup ProcessKensington Security Slot Provisioning Access Points Aruba Discovery Protocol AP Provisioning AP Reprovisioning1Provisioning Tab 2Port Range Screen Manual Provisioning RequirementsProvisioning Access Points Connecting the Console Terminal Console Access to the AP1Console Terminal Settings Dram 32 MB Setting Aruba AP 60/61 Parameters Apboot setenv servername aruba-masterMy network uses direct IP addresses instead of DNS Apboot save apboot boot Provisioning Access Points AP Deployment Mounting the Aruba AP 60/61Aruba 60 Detachable Antennas 1Aruba AP 60/61 Mounting Options1FCC-Approved Detachable Antennas Aruba Description Gain Manufacturer DbiAP-ANT-8 Free-Standing Placement 2Aruba AP 60/61Fold-Out StandUsing the Built-In Mounting Slots 3Mounting Screw SpecificationsUsing the Optional Mounting Kits 4Hanging the Aruba AP 60/61 on ScrewsConnecting Required Cables Selecting an FE CableConnecting Cables & Power Maintenance Selecting an AntennaAccessing the AP Support Prompt Direct Spoe Connection to Mobility ControllerDirect Terminal Connection Table A-1Console Terminal SettingsBaud Rate Data Bits Parity Stop Bits Flow Control 9600 None Setting Telnet Access Remote Telnet ConnectionAccess Levels User CommandsPrivileged Commands AP SupportResetting the AP to Factory Defaults Troubleshooting FE Port Figure B-1Aruba AP 60/61 FE PortTable B-1Console Terminal Settings DB-9 SpecificationSerial Breakout Adapter To AP Specifications To Network SpecificationsPort Specifications United States ComplianceFCC Class B Canada RF Radiation Exposure StatementRadio Frequency Interference Requirements RSS-210Europe JapanIndoor Restriction for 5GHz Frequency Range Vcci Class B Product Specifications Certifications MeasurementProduct Features Radio CharacteristicsProduct Label Ethernet CompatibilityPower Over Ethernet Package ContentsPhysical Description Optional ItemsAruba AP-60 Access Point Figure C-1Part Number AP-60Table C-1AP-60 802.11 Specifications Description 802.11a 802.11b 802.11gAble C-1 AP-60 802.11 Specifications ACKAble C-2 AP-60 Characteristics BssidAP-60 Characteristics Aruba AP-61 Access Point Table C-2AP-60 CharacteristicsTable C-3AP-61 802.11 Specifications Description 802.11a 802.11b 802.11gAble C-3 AP-61 802.11 Specifications Able C-4 AP-61 CharacteristicsAble C-4 AP-61 Characteristics Table C-4AP-61 Characteristics Related DocumentsText Conventions Table C-5Text ConventionsTable C-5Text Conventions Contacting Aruba Networks Telephone NumbersProper Disposal of Aruba Equipment Product Specifications Aruba AP 60/61 W . a r u b a n e t w o r k s . c o m