AP Deployment | 3 |
|
This chapter covers the following topics:
zPhysical mounting of the Aruba AP 60/61
zConnecting the required cables
Mounting the Aruba AP 60/61
When provisioning is complete, mount the Aruba AP 60/61 at its intended service location.
The Aruba AP 60/61 Access Points with or without external antennas are intended only for installation in Environment A as defined in IEEE 802.3.af. All interconnected equipment must be contained within the same building, including the interconnected equipment's associated LAN connections. (When using an external antenna, 5.150 to 5.250 MHz are blocked.)
Select a location as close as possible to the center of the intended coverage area. If necessary, use the Aruba RF Plan site survey tool to determine the optimum locations for your access points and air monitors.
The service location should be free from obstructions or obvious sources of interference. Normally, the higher you place an access point or air monitor, the better its performance.
If external antennas are used, make sure that they and their associated wiring are located entirely indoors. The Aruba AP 60/61 and any optional external antennas are not suitable for outside use.
Aruba AP 60/61 21
Installation Guide
