7)After your spa is operational you must install the Spa Cover latches. The locks will already be attached to the end of the straps. Position the tie strap so it is fully extended, without stretching. Locate the 2 holes on the locking mecha- nism, marking them with a pen. Remove the locking mecha- nism from the strap and fasten to the spa.
HAZARD
Never leave an uncovered spa unattended, and never leave a covered spa unlatched.
SPA OPERATIONS GUIDE
Topside Control Component Identification
Topside Indicator Icons
Pump 
Light 
Filter 
Heat 
Temperature
Heat➔and Heat➔ buttons
The spa’s thermostat is to provide you with optimum control of the spa water temperature. This temperature set point can be adjusted from 15°C (40°F) to 40°C (104°F).
Note: if you have a blower button on the topside digital control pad then you will only have one button for heat up and heat down. By holding the heat button down for 3 seconds you can either heat up or heat down. Press the heat button again for 3 seconds to do the opposite.
13
