CIRCULATION PUMP
OPTIONAL PURCHASE ON THE DELUXE ARUBA SPA
STANDARD OPTION ON THE EXECUTIVE ARUBASPA
The circulation system is operated by a 1/15HP motor that
draws about 1 amp. You can not operate the circulation sys-
tem from the topside control as it is pre-programmed to run
24 hours a day. The circulation system efficiently circulates
the spa water through the filtration system, as well as purg-
ing water from the lines for one (1) minute every 12 hours on
high speed of the main pump.
When you start up your spa ensure that both knife valves on
either side of your circulation pump are in the open position
(up). Loosen the union to release any air, then re-tighten.
Ensure that the cord to the circulation pump is plugged into
the spa pack tightly.
AQUA PURE WATER SYSTEM
OPTIONAL PURCHASE ON THE BASIC ARUBA SPA
AND THE DELUXE ARUBA SPA
STANDARD OPTION ON THE EXECUTIVE ARUBASPA
The Aqua Pure Water System is an automatic bromine gener-
ator that is virtually maintenance free.
Sodium bromide is added to the spa water. Once it is dis-
solved, it circulates through the plumbing to reach the elec-
trodes which convert it to free bromine before reverting back
to sodium bromide (it is a perpetual cycle). Additional sodi-
um bromide is only added when the water level declines due
to splash out, or when spa is drained/filled.
- Fill spa with water up to the water line
- Make sure the DECREASE/INCREASE dial on the face of
the Aqua Pure Water System is turned to the OFF position.
- Balance your alkalinity
- Balance your pH
- Make sure that the spa’s pump is turned on to low or high
speed
- Add 4 1/2 bottles of TRU BLU sodium bromide evenly
over the surface of the water, shaking each bottle well first
to break up any lumps
21