IBM OS/2
6.Modify the CONFIG.SYS file on diskette #1 to include the following line: BASEDEV=AIC7870.ADD
7.Run the IBM OS/2 installation program; follow the instructions in your IBM OS/2 documentation.
8.At the end of the installation process, follow the on screen instructions to re- move the last IBM OS/2 distribution diskette and reboot the computer. If the computer fails to boot up, and locks up while displaying the IBM OS/2 logo screen, you may use one of the following options to get to the command prompt:
a)If you installed IBM OS/2 using the FAT Filesystem, boot up
b)If you installed IBM OS/2 using the HPFS Filesystem, insert the Installation Diskette and boot up the computer from this diskette. When the IBM screen is displayed, remove the Installation diskette and insert Diskette #1 as instructed to do so. After a while, a screen will be displayed asking which installation method you wish to choose. At this point, press the F3 key to get to the com- mand prompt. Once you get to the command prompt, change to the drive where the IBM OS/2 system files are located (usually Drive C:). You may now use a text editor to again modify the IBM OS/2 CONFIG.SYS file on the hard drive to add the /!PCIHW switch to the BASEDEV=AIC7870.ADD line. IBM OS/2 should then boot normally from the hard disk.
9.After the computer has restarted, IBM OS/2 displays a screen. You have the option to view online information while the IBM OS/2 desktop is building. Al- low IBM OS/2 to finish building, and follow the on screen instructions to restart the computer. Again, if the computer fails to boot up, and locks up while dis- playing the IBM OS/2 logo screen, repeat the process specified in step 8 to correct the problem.
NOTE: The CONFIG.SYS, IBMINT13.I13, and OS2LDR files may be over- written by equivalent files from the
B. LAN Driver
WINDOWS NT 4.0
B.
IBM OS/2
ASUS | 109 |