WINDOWS NT 4.0
D. Install Adaptec AIC-7890 Driver
If you are performing a first time Windows NT installation, see the "Installing Windows NT v4.0 with the FMS Driver" sections below.
If Windows NT is already installed on your system, see the "Updating the FMS Driver under Windows NT v4.0" sections below.
Installing Windows NT v4.0 with the FMS Driver
The following instructions explain how to install the Adaptec 7800 Family Manager Set v3.01, while installing Windows NT v4.0.
1.Start your system with the Windows NT Boot Diskette in the floppy drive.
2.Insert diskette #2 when prompted. After a few moments you will see a blue screen. To setup Windows NT now, press ENTER.
3.Press S to skip Windows NT Setup's auto detection of your SCSI adapter.
4.Press S again to specify an additional device.
5.Press ENTER to select Others, and insert the Adaptec 7800 Family Manager Set v3.01 diskette.
6a. For
6b. For Ultra2 host adapters, Select the "Adaptec
7.If you want to add other host adapters (that are not a part of the 7800 Family), do so at this time by pressing 'S' and repeating step 5 for each additional adapter and inserting the appropriate disk provided by the hardware manufacturer. The Adaptec 7800 Family host adapters use the same driver; it is not necessary to install the AIC78XX.SYS or AIC78U2.SYS driver again.
8.Press ENTER to continue with the Windows NT operating system setup. Follow the instructions given on screen and in the Windows NT installation documenta- tion.
D.
WINDOWS NT 4.0
ASUS | 85 |