IBM OS/2
Installing from DisketteTo install the Vision864/964/868/968/Trio32/64/64V+/64V2 device driver from dis- kette, do the following:
1.If system is not in VGA mode, select VGA mode.
2.Insert the Vision864/964/868/968/Trio32/64/64V+/64V2 diskette into drive A (or any other diskette drive).
NOTE: "S3 DRV1" must be the volume label of this diskette. To verify the label, use "Label A:".
3.Open an OS/2
4.At the OS/2 command prompt, type the following command to copy all neces- sary files to the OS/2 drive:
A:SETUP (where A: is the diskette drive) Then press <Enter>.
Setup will then identify your chipset. When prompted to do so, press <Enter> to continue. Due to the limitations with a single pass installation, a dialog box may come up during installation with the message, "The installed adapter does not support the selected display driver. Do you wish to continue?". Please continue the installation by selecting the Yes button.
5.When the Monitor Configuration/Selection Utility window appears, the "Install Using Defaults for Monitor Type" choice is preselected. Select OK. Do not select "Install Using Display Adapter Utility Program" since this method of set- ting refresh rates is not supported anymore.
NOTE: DSPINSTL determines the hardware configuration by creating the \OS2\SVGADATA.PMI file. If the \OS2\SVGADATA.PMI file has not been created, the adapter will not be supported. This process can take several sec- onds and will
6.When the Source Directory
7.When prompted to do so, select OK to perform a shutdown, and then restart your computer. Make sure the diskette has been removed from the install drive.
A. VGA Driver
IBM OS/2
ASUS | 97 |