IBM OS/2
Setting Your Display to VGA Mode
Use the following procedures to reset to VGA mode.
NOTE: If your display is out of sync, start OS/2 using the OS/2 Installation Dis- kette. Insert Diskette 1 when prompted, press F3 to display a command prompt, and then use the following instructions to reset your display mode.
•If you are installing this driver on OS/2 2.11 or OS/2 for Windows, and you installed from diskettes, do the following:
1.Under OS/2 2.1/2.11, before running RSPDSPI, delete the following file: [OS2 DRIVE]:\OS2\INSTALL\00S3.DSC
2.Be sure RSPDSPI.EXE is in the \OS2\INSTALL directory. If it is, go to step 5. If it is not, insert Diskette 8 into drive A and unpack RSPDSPI.EXE with the following command:
C:\OS2\UNPACK A:\INSTAID C: /N:RSPDSPI.EXE
where A: is the drive containing Diskette 8, and C: is the drive where OS/2 is installed.
3.Type C: and then press <Enter>.
4.Type CD C:\OS2\INSTALL and then press <Enter>.
5.Type the following:
RSPDSPI /PK:VGA /SK:NONE /S:A:\ /T:C:
In /T:C:, C: is the target drive where OS/2 is installed. In /S:A:, A: is the source diskette drive for installing the device driver. Then press Enter.
6.Perform a shutdown and restart your computer.
•If you are installing this driver on OS/2 2.11 or OS/2 for Windows, and you installed from
1.Under OS/2 2.1/2.11, before running RSPDSPI, delete the following file: [OS2 DRIVE]:\OS2\INSTALL\00S3.DSC
2.Be sure RSPDSPI.EXE is in the \OS2\INSTALL directory. If it is, go to step 6. If it is not, unpack RSPDSPI.EXE with the following command:
C:\OS2\UNPACK E:\DISK_8\INSTAID C: /N:RSPDSPI.EXE
where C: is the drive where OS/2 is installed, and E: is the
3.Type C: and then press <Enter>.
4.Type CD C:\OS2\INSTALL and then press <Enter>.
A. VGA Driver
IBM OS/2
ASUS | 95 |